Request for Quote

REORDER EXISTING UNIT

Serial #

If a new purchase, please fill out the information below:

SKIPCHEK SPECIFICATIONS

1. 1st C.F. +.062/–.000 in. ( +1.6/–0.0 mm.)

2. F.F. +.000/–.062 in. ( +0.0/–1.6 mm.)

3. Total SKIPCHEK stroke in. (mm.) Nominal

4. Drill thrust lbs. ( kg.)

SKIPCHEK will be tested at 150 lbs (68 kg.) if no thrust load is specified.

REFERENCE DATA

5. Round tube: Yes       No

If yes: O.D. in. ( mm.)

wall thickness in. ( mm.)

6. If work material is not round tubing:

Specify: Thickness of 1st section in. ( mm.)

Distance between sections in. ( mm.)

Thickness of 2nd section in. ( mm.)

7. Drill Dia. in. ( mm.)

Point angle degrees (included)

8. C.F. Feed Rate in./min.( mm./min) (if known)

Specification items 1 thru 3 are mandatory information we must have. Item 4 will not have an appreciable effect unless thrust loads exceed 350 lbs. Items 5 thru 8 are for the user's consideration to be sure all aspects have been considered including part curvature, drill point height etc. The transition tolerances shown on the design sheet are necessary and must also be allowed for when establishing specifications. See here for full product specs.

Note: C.F. means controlled feed. F.F. means fast forward (skip).

Note: Drill point height, transition tolerances and part curvature (if any) should be considered when establishing specifications.

Completion of the reference data will assist in establishing 1st C.F. and F.F. specifications. (Transition tolerances increase C.F. or decrease F.F. as shown.)